ProductsExpressFabStoneCabinetMetallater(208) 590-7702
Start free trial
Help / Jobs

Sheet offcuts and sheet yield

An offcut is a piece of a sheet that is big enough to keep. ExpressFab tracks each one, so a small part comes out of an offcut before anyone cuts a full sheet.

See what's on the rack:

  1. Click Inventory (under Production).
  2. Click the Offcuts tab.
  3. To find one big enough, type the length and width you need next to Fits.

Each piece shows its material, thickness, size and where it sits. Over 90 days on the rack shows the ones to use or clear out.

Add an offcut:

  1. Click Add an offcut.
  2. Pick the sheet it came from under Material.
  3. Type its length and width in inches.
  4. Pick which way the grain runs, if it matters.
  5. Pick the job it was left from, if there is one.
  6. Type where it sits, like Offcut rack, slot 4.
  7. Click Add.

If the piece is smaller than 24 by 12 inches, the app asks before it keeps it. Small pieces fill a rack fast.

Print a tag. Open the offcut and click Tag. Stick the QR tag on the piece. Scanning it with a phone opens that piece, to hold it, use it or move it.

Use one on a job:

  1. Open the job.
  2. Find the card Sheets and offcuts.
  3. If Ed found offcuts for this job shows, click Hold it next to one. Ed lists offcuts that match the sheet goods on the job's bill of materials.
  4. Or click Use an offcut and pick one from the list.
  5. When it's cut, open the offcut and click Use it. If a usable piece is left, type its size and it goes back on the rack.

An offcut held for a job is marked used by itself when the job reaches Production.

Save what's left after a nest. On the job's Sheets and offcuts card, click Save an offcut. It goes on the rack with the job's number on it.

Sheet yield, by job:

  1. After the nest, open the job.
  2. On Sheets and offcuts, click Sheets cut and yield.
  3. For each material, type how many sheets it took.
  4. Type the yield your nesting software reports for that material, as a percent. Leave it empty if you don't have it.
  5. Click Save.

The job then shows what became parts, what went back on the rack as offcuts, and what was scrap. A full sheet counts as 4 by 8 feet, 32 square feet.

Across jobs. Reports has a Sheet yield card: the average for the period, and the jobs with the lowest yield first.

What an offcut is worth. Each offcut carries its share of the sheet's cost, so In stock, at cost on the Offcuts tab is what's sitting on the rack.

This is the manual that's inside the app, where every screen also has Ed to ask. Still stuck? Contact support.